The K-Drill - Cordless Drill Electric Ice Auger System

Kluge Drill Attachment As Seen on Ice Fishing Today

Here is the ultimate drill assembly designed for hand held cordless electric drills. Using high carbon steel chipper blades, this Drill assembly is designed specifically for re-drilling old holes. The unique centering pin greatly reduces blade jump and allows for a quick and clean hole time and time again when using permanent fish houses. The composite flutes are not designed to throw ice shavings around the inside of your fish house, but instead is designed to make it very easy to remove the ice without getting ice all over the floor.

The K-Drill has its own floatation system to prevent it from sinking down the hole if it comes detached from the drill. Requires a minimum of an 18 volt, high-torque drill for best results.

The K-Drill requires a 1/2 inch drill chuck electric drill. We've found the best drill for the job is the new Milwaukee M18. M18 drills comes with two battery packs and a charger. Each battery is capable of drilling 20 holes in 24 inches of ice.

  • Cutting Speed: 1 inch per second
  • Total Weight: < 10 pounds
Best Electric Ice Auger - Milwaukee M18

8 " K-Drill: $249.95
6 " K-Drill: $199.95


Quantity:

Best Electric Ice Drill - Milwaukee M18

 

Kluge Drill Attachment

Kluge Drill Attachment As Seen on Ice Fishing Today

The Kluge Electric Auger Drill Adapter by KECO is chuck mounted and is the most convenient way to get your hand ice auger working for you. Open the chuck, when you get home, and your cordless drill is ready for another job. Chuck mounting leaves open the possibility your drill will come out of the chuck at the worst possible time and your ice auger goes down the hole. This KECO adapter has cross arms that rotate freely on the shaft to stop the drill at the ice surface. Three drive flats are used for the most secure chuck mounting.

This innovate product simply fits into any 1/2" electric drill. No special chuck is required. We do recommend the use of a drill that offers a low gear ratio since electric drills often go from 0 to 100% so fast, the drill could spin right out of your hand if the auger bit gets stuck. The auger attachment is simply the bottom end of a hand auger. You will need to go to your local ice fishing dealer to buy the hand auger separately and easily attached it to the adapter.

Kluge Drill Attachment: $45.00

  

 


Site by Element Engage